![]() ![]() Its connected to the microphone jack on my radio, with the cable it came. I will provide my phone number upon request. If you haven’t configured the jumpers inside the Signalink yet (open it up and connect the supplied small jumper wires accordingly, rtfm), consider purchasing the appropriate jumper module to install inside the Signalink (it replaces the small wires). E-Mail help would be great, but a phone call to verify various settings would be even better. I could really use someones expertise in getting FLDIGI set up correctly. ![]() Also, (I think unrelated to my main problem, when in receive the waterfall background is yellow with red speckles that I assume is the receive static background. How to Setup FLDIGI FlDIGI software has five components used for this presentation: FLDIGI. Zello is a popular walkie talkie / push-to-talk. On the Fldigi screen, press the Tune button at the upper right. Set the Speaker slider at about 90 and the Wave at a little over 50. Select the USB Device (USB Audio CODEC) Playback. Go to the computer’s sound controls and open the Playback controls. Read the installation manual carefully 3 times for your. Windows 7/8/10 on the SignaLink or radio gateway side and iPhone/iPad or Android phone/tablet app on the other end. The SignaLink should be turned on and the radio, if connected, turned off. When I key the Tune button in FLDIGI, I do get the single red line at the correct frequency, but the waterfall also has light white lines about every 50hz across the waterfall. I needed another toy, so why not interface my TS-450S with a SignaLink USB to my Win 10 laptop. Winlink and FT-8 both work perfectly with no issues. I did get it to work correctly when playing with the Comm ports once, but then the following morning it reverted back to the same problem. The CODECs are selected for Transmit and Receive, but maybe I must still not have something correct. I am using two cables between the laptop and the radio, one to the Remote serial jack for rig control from ACLOG and one to the USB-B jack for audio input. However, when I key the Tune buton in FLDIGI, no tone goes to the radio from FLDIGI only the microphone input from the Laptop. And the Tune button in FLDIGI does correctly key the radio. FLDIGI correctly shows the radio's frequency. I am currently trying to get FLDIGI working correctly with my home station, the IC-7851 and Laptop. I have an IC-7300 with a Tablet PC hooked up and an IC-7851 with a Laptop hooked up, both having the same problems. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |